SimTech WeldTech Instrukcja Użytkownika Pobierz pdf (Strona 22)

WeldTech - MaxiPlast Instruction Manual

SIMTECH

Phone: 877-777-2467 • Fax: 215-547-3410

www.SimtechUSA.com

1.031213

7. Maintenance Instructions

Goal of the chapter is:

• Keeping of the nominal state and the operation capacity of the machine.

• Increasing of the efciency by avoiding non-planned outage.

• Efcient planning of the maintenance works and the maintenance tools.

7.1. General

Replace damaged parts immediately, be particular cautions with electrical parts - dirt and

wetness are very good current conductors.

Prescribed maintenance and inspection works should be performed in time. The DVS gives

the advice of inspection works after 1 year.

For machines with a specially high usage percentage the testing cycle should be shortened.

The works should be performed at SIMTECH or by an authorized partner.

7.2. Clamping elements

• For a long service life clean and grease regularly the treaded spindles and the joint parts which

are used for clamping the pipes.

7.3. Planer

• Never lay the planer onto its discs !

• The blades of the planer must be checked for sharpness. Wrong blades must be either turned

over (double sided) or replaced (max. thickness of the shavings =0,2 mm!)

7.4. Storing

• Cover the guidance bars and the spindle with thin oil lm.

• Store the machine dry.

7.5. Cleaning of the machine

The used materialis and clothes have to be handled and disposed off properly especially

• When cleaning with solvents

• When lubricating with oil and grease

8. Transport

• Protect against bumps.

• Handle the machine with care.

• Make sure that the box is closed correctly.

• The machine is transported by means of a transport box out of steel. The single elements are

placed within the steel transport box.

• The steel transport box contains a rectangular insert for the planer.

• The basic machine and the table support are put at the side of the planer.

• Insert heating element with cable and temperature control in such a way that it remains

beyond the strip for the reducer inserts.

• Insert both cotainers containing the reducer inserts.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Brak uwag

SimTech WeldTech Instrukcja Użytkownika Strona 22